Chamsys MagicQ User Manual Manual do Utilizador descarregar pdf (Página 229)

MagicQ User Manual 200 / 355

Table 24.1: (continued)

Attribute Attib No Default Encoder Function

Cont7 44 B4F

Cont8 45 B4E

Frame 52 B5A Top left

Frame 53 B5B Top left

Frame 3 54 B5C Bottom left

Frame 4 55 B5D Bottom left

Frame 5 56 B5E Top Right

Frame 6 57 B5F Top Right

Frame 7 58 B5Y Bottom Right

Frame 8 59 B5X Bottom Right

The Enc ﬁeld speciﬁes which encoder position in the Intensity, Colour, Position, Beam windows the attribtue appears on. The

Enc ﬁeld is defaulted based on the choice of Attrib No - this provides a common interface across all heads. In some circumstances

users may wish to modify the allocated encoder in order to bring similar attributes onto the same page.

The encoders are positioned as follows:

Encoder A Encoder E

Encoder B Encoder F

Encoder C Encoder Y

Encoder D Encoder X

There is one page each for Intensity, Position and Colour and ﬁve pages for Beam.

The Size ﬁeld is used to specify the size of the attribute. For channels that are only 8 bit the Size ﬁeld is set to 8 Bit. For 16bit

channels the coarse channel is set to 16 bit Hi and the ﬁne channel to 16 bit Lo. For channels with 24 bit resolution set the lower

two channels as for 16 bit and the highest channel to 24 Bit Hi.

The Instant ﬁeld speciﬁes whether a channel by default snaps immediately to new values rather than fading – this is useful for

colour wheels and gobo wheels where you want immediate changes.

The Slow Encoder ﬁeld makes the encoder works more slowly than normal. This is good for attributes where every possible

DMX value represents a different function and therefore only very small turns of the encoder are required to change function.

The Default ﬁeld deﬁnes what value the channel is set to by default on start-up. When the Setup, Programming option “Unused

chans return to default” is set then channels also return to these values when they are no longer controlled by Playbacks or the

Programmer.

The Locate ﬁeld deﬁnes what value the channel is set to when a Locate is performed on the head – it is also used as the default

value for a channel if no default values is speciﬁed.

The Default and Locate should specify the normal defaults for the ﬁxture – the exact values used in a particular show can be

overriden by making a Default Cue or Locate Cue in the Cue Store.

The Highlight and Lowlight values are used when the Setup, Programming option Highlight mode is set to Advanced. This

enables the user to conﬁgure custom highlight/lowlight settings for each type of head.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 383 384

Sem comentários

Chamsys MagicQ User Manual Manual do Utilizador Página 229