Chamsys MagicQ User Manual Manual do Utilizador descarregar pdf (Página 292)

100

101

MagicQ User Manual 263 / 355

When you have connected your Scene Setter to your the PC and the Digi Utiltly has loaded up, it will automatically look for the

Scene Setter over your network. Once set up you can change the IP Address.

Advanced Scene Setter Conﬁguration

The Scene setter can be remotely conﬁgured using a web browser.

Type the IP Address of the device into a web browser. You should see a login box. The username and password are as below.

Once you are logged in then you can conﬁgure all the settings of the network module in the Scene Setter. Note that if you change

the IP address of the Scene Setter then it will be necessary to use the new address in your browser address bar.

38.5 Setting up the Serial Port

The serial port on the scene setter is set up at ChamSys so it should not be nececsary to change these settings. If the conﬁguration

is lost for any reason then from the web browser connected to the Scene Setter:

• Change Proﬁle

• UDP Sockets

• Enable UDP port using port 6554.

• Then set it to "Automatically Send Data" on to 2.255.255.255 port 6554.

• Send when data is present on the line and match "mahC".

• Untick "Send after following number of idle milliseconds"

Then Apply these settings.

Also set the Basic Serial Port settings to 9600, 8 bits, 1 stop bit, no parity, and no ﬂow control.

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 383 384

Comentários a estes Manuais

Sem comentários

Chamsys MagicQ User Manual Manual do Utilizador Página 292

Comentários a estes Manuais